140 is load amps for a equipments and what ratio of CT
requied for installimg ammeter to amps montering purpose?
- 1 Answers
- 3413 Views
- I also Faced
- E-Mail Answers
Answer Posted / parminder
200/5 AMP IS SUITABLE
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how open delta PT works & what is its construction?
Safety of on line ups
When lag/lead/lag-lead compensation is employed?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
how can you size an automatic voltage regulator?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
why swityard is necessrry requirement in any bis power distributin systems?
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
previous year paper of ntpc bhel for degree in electrical enng
What is the approximate value of stacking factor?
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
