What is Wlak Test in Fire Alarm System????
- 2 Answers
- 4539 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / joy
walk in test in a FDAS is a built in program done in the
Fire alarm control panel where you can test each zones
assigned. It is an automatic testing program to see if all
detectors connected or located from different areas of the
building is really working or if one detector in a zone fails.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is cathode ray oscilloscope (cro)?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
what is value of Jin transformer
how to select rating of HT Panel
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What does quality factor depend on in resonance?
where was current transformer protection units used and why??
how does directional relay work incase of ac ?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
why 1.7Uo for HV cable Hi pot test?IE standard why?
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
How to perform a DC resistance test In Alternator and their proceduces?
What is principle of Floroscent tube 36watt.
what is the usage of microcontroller in the panel board?
if sf6 gas low in gis what will happen
