Answer Posted / azmi abullais
Q=A*V
A=area in square feet,
V=velocity in feet/min.
Q=flow in cfm
but as we knw the thumb rule
90-110 sqft / tr we always taken
| Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
sir i need section engineer test papers
what is punching force required for embossing of depth 3.5mm and diameter 58mm
Quantities like pressure, temperature, density, viscosity, etc. Are independent of mass. What are these called ?
How to calibrate Vacuum Gauges if you don't have any standard gauge available with you? please suggest procedures for calibration of Vacuum gauge like pirani gauge ,cold cathod gauge,thermocouple gauge without any standard gauge.
why we are using mineral wool as insulation material than glass wool , in india?
What is the temprature used in dearator tank?
Is the hvac machines are designed 10% less than the electrical feeder value?
where can i get railway junior engineer(mechanical) previous years question papers?
What do you do to prevent flare black?
What are the factors that can affect the factor of safety selection?
What will happen if you blow the soot in the boiler?
What is conduction?
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
What is the use of outside micrometer?
In 1983 what changed about the length of the meter?
