Answer Posted / waqas ali

Two methods:
1. Using multimeter which should have a built in provision
for checking of diode.
2. Connect +ve terminal of a 12VDC power supply to Annode
of diode and -ve terminal to the cathode. Check with
multimeter the voltage drop across diode. If it is ~0.7V,
then it's OK otherwise it's faulty.

can we copy the software from a transmitter using hht(hart 275) ?

1629

---

What is difference between differential pressure & delta pressure?

609

---

How to calculate P,I&D value in PID controller ?

1618

---

Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

1677

---

Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?

2106

---

---

what is the process for double acting cylinder pneumatic for 32' v/v

1626

---

any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.

1938

---

Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com

1683

---

In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?

1613

---

what is the diffrence between pressure safety valve & pressure relief valve....pls

1724

---

What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.

1796

---

what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other

1668

---

how will you segregate the alarm levels in alarm management system during factory Acceptance Test

1920

---

I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.

1885

---

What are the application of bernoulli’s theorem?

682

---