Answer Posted / peddapalli saikumar
Multiplex is a process of transfering the two signals(address and data). in the only port 0 section performs the mulplexing operation for transfering the both the add. and data...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
• The silicon of a new device has memory leak. When all "0" are written into RAM, it reads back all "0" whithout any problem. When all "1" are written, only 80% of memory cells are read back correctly. What can be possibly the problem with the RAM?
What are potential transformers?
Why should you chosen this job
How can increase strength of EMF in AC motor?
12. Multiprogramming nd multithreading.. Which of these are better? a.multiprogramming b.multithreading c.depends on the system d.both are efficient
What is difference between fixed-bias circuit & self-bias circuit?
What is pass band?
explain the application of a jfet.
when you are from engineerng back groung student then y r u choossng bank job? plz give me best answer
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
What is he use of embeded systems?
pls send me mahagenco previous entrance exam question papers
What is capacitor?
Give the typical value of bias current for ca741 operational amplifier.
why we cant ermove total hard ness of water
