Answer Posted / ravindra
pf =1 resistive . but for power delvring p=v1*v2sin(q)/x .x
inductance requir, .as pf from lagg to start leading by any
how or means voltage profile started impoving but the power
angle at unity pf becomes 45 to 75 but the permissible value
of q angle is 0 to 15 degree.so for the stability point of
view pf near about 1 but not exact 1 remain
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Define rise time.
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
Inverter. converter. Ups.MCB.solar.alternators. motors.
What is voltage ratio of a transformer?
What is line resistance of cable & how it can be measured ?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
can any tell me why slope 40% and 80% is calculated in differential protection?
Give some differences between open loop and closed loop control systems.
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
