In most process, speed of motor controlled by control
system with a reference pot . Now if i start & it becomes
uncontrollable, i.e.gets directly start & stop after certain
time.Then which reasons can make such problem? can motor
may be faulty?how?
Answer Posted / an70n
faulty or defective tacho generator
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
what are the steps I have to deal with?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is the use of single seated valve?
How to Calibrate Ultrasonic flow Transmitter in Field
what is the diffrence between pressure safety valve & pressure relief valve....pls
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is The specifications for oriface instalation
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?