WHEN THESE TRANSFORMERS WINDINS CONFIGURATION ARE USED?
SPECIALLY EXPLAIN REGARDING STEP UP AND STEP DOWN KEEPING
IN MIND.AND REGARDING LOAD ALSO.
a.star to delta
b.delta to star
c.delta to delta
d.star to star
ALSO EXPLAIN WHY V USE 415/415 TRANSFORMERS IN TUBEWELLS?
- 1 Answers
- 3206 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Depending on application. 1:1 ratio tr is for isolation of
earthed neutral of primary.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how to compute kAIC? with formulas...
why ht cable end termination don't have a gland?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
Difference between Lugs and Thimbles
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
What is the diff. between single compression and double compression gland
raleigh method
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
What do you mean by passive circuit elements and why these are called passive?
What are approaches to tackle sedimentation problem of reservoir?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
