Answer Posted / k.prakashchandra
The secondary neutral is not earthed and it is galvanic-ally
isolated from primary neutral
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1.what is the reason for transformer and lightning arrester blast in 33kv system
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
What is Annunciation?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
salam,hi, i need to know what the spesification of 300amp msb...
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
How to setting the volume of RTCC panel AVR (11kv) controller
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
why ht motors are star connected?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
what is reactive power?, why its measured in VA ? is it transient behavior of system?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
