Answer Posted / prakash kumar

that is pascle. it is denoted as pa.and its unit is psig.

what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..

2164

---

DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.

1908

---

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

2096

---

what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?

2041

---

Can anyone send most commonly asked interview question in Oil & Gas industry

2270

---

Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...

2357

---

If P will increase then what will happen with PID?

6072

---

can anyone tell me about the basic concepts to consider before to start a PLC panel wiring

1950

---

Draw symbols of the following :

1990

---

List three types Level Gauges with their working principles

2094

---

what is the difference between active & reactive power?

2209

---

What are different type of instrument cable

2285

---

What is 3 element control system

1501

---

the 3 most common transmitter protocol being in refinery or qatar gas and aramco.

2957

---

What is the basic difference between Modbus and CAN Open Protocols

6457

---