why we choose 50 or 60 hertz not other value for the power
system?
- 4 Answers
- 6525 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj kumar
we can use amy frequency,,,but to stablity of power
system,all equpments are runed under same frequence,in our
country we fixed 50 hzs,,,,
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
What is the use of bundle conductors?
Why an ac systems are preferred over dc systems?
What the difference between ac and dc inductor an capacitor
Is MEN and RCD related to each other ?? IF yes then how??
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
what happen when increase or decrease size of lamp,light.glass.
wht is embedded systems? what is new inthis field?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What are the types of control system?
what is the meaning of 0.5ohm Resistance
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Why cables and busbar both needed in LT Panels?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
what is the differebt between ac and dc fuse?
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
