Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bcd
1.insulation required is more
2.terminal apparatus(CB etc.) used for hvdc is costly
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
WTA used cb?
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
Different types of relay fault which phase sequence??
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
how to measure earth resistance of a substation
What is the approximate value of stacking factor?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
why impedance relay is used for medium transmission line protection
how load of a turbo generator can be increased
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
