Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / varun kumar
It maintain the drum level with the help of making balance between feed water and steam flow.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Tr. Wiring for calibration.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
How servomotor controls throttle valve of TURBINE?
how to calibrate steam control valve in steam turbine
what is sliding spool valves?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
which type of signal used in instrument?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
What is the use of gauge?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
