what is phase to phase voltage? what is line to line voltage
- 46 Answers
- 130284 Views
- Exmar, HBL Power Systems, I also Faced
- E-Mail Answers
Answer Posted / unknown
Phase to Phase Volatge is referred to as Phase Voltage and
the formula is ......... Vphase = Root 3 * 240V = 415V
whereas
Line to Neutral is simply called Line Voltage and it is
Vline = 240V
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
Classify driling machines.
what is the difference between elcb and rccb ?
what is the method of earthing of a transformer using electrodes?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
how to decide choke rating for drive?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
What is pi controller?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
Why do we perform an open-circuit test and short-circuit test on the transformer?
