While performing load test on DC SERIES MOTOR, does the
voltage decrease slightly. Why?
- 2 Answers
- 5513 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
while comparing with the other motors during load test,the
fall in voltage level of the dc series motor is low.this is
because of the series connection of the armature & field
winding.
The load torque developed by the other dc motor is
proportional to the Ia & flux(phi).But for series motor, it
is square of the Ia. so, for the same armature current dc
series motor develops more torque than the other dc motors.
i.e series motor draws comparatively less current from the
supply for the same load torque developed by the other dc
motors.As the current level decreases, the drop in voltage
level also decreases (IR drop).clear.....friend.....
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
What types of question are done for diploma students in aptitude test
Why does inductive loads consume KVARs?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
How does a transformer contribute towards the widespread popularity of ac system over dc?
describe the fully control circuit diagram of ac drives
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
what's producer of XLPE cable laying in undergroung
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
How to do stting of vl250 siemens MCCB
