How can we Run three phase motor when only single or two
phase supply is available ??
- 3 Answers
- 4802 Views
- I also Faced
- E-Mail Answers
Answer Posted / sparta
yes, we can run the motor by using 1,or 2phase, for that we
have to used capacitor or inductor for any one phase to
convert two phase into three phase system
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
What is the efficiency during maximum power transfer?
How to calculate main incomer rating of APFC Panel ? Let's say i want to find main incomer for 11kV, 1000kVAR Panel.
comparision between ACB and VCB
concept of busbar and load dispatching..?
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
what is the working principle of a DG Set, Alternator, & exiter
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Earth bits close or open. Which is correct
how could we calculate the no of outgoings from a 800 watt distribution board
how can you calculate fault level ?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
why electronic instruments is more favorable than electrical?
