voltage at generation stage is usually- ?
a.11kv b.33kv c.66kv d.220kv
- 12 Answers
- 18348 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay
In india,alternator terminal voltage is3.3kv then through the transformer it is step up to 11kv and given to the plant substation and there it is made 33,66,132kv according to the grid voltage.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is doubling factor in making current of a breaker?
Explain what cmos is and its benefits?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is the type of feedback used in an op- amp schmitt trigger?
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
what is the effect of power factor of machines in starting current
what are the interview question asked in wind mill about electrical
Why ground terminal is used in pot meter 10k ohms
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
Explain what is use of lockout relay in ht voltage?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
how is working bearing heater?
