What is the diffrence between PL Lamps and CFL Lamps
- 5 Answers
- 79717 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhiren
PL Lamp:A nickname for a twin tube fluorescent lamp coined
by Philips Lighting, a large manufacturer of lamps. Compact
Fluorescent Lamp (CFL): a generic name used for a whole
family of small, single-ended fluorescent lamps with a
folded, bridged, or spiral glass tube design and with high
color rendering (CRI>80) and a long life (>8,000 hours).
| Is This Answer Correct ? | 22 Yes | 37 No |
Post New Answer View All Answers
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
How can we increase fuel-power ratio of any DG set?
Can double compression glands be used with regular cables?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
What the main causes of transient interruptions on Over-Head Distribution Lines?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is a synchronizing lamp ?
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
could you measure current in parallel?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
please forward me the type of questions which would rise while me attending to 33KV Electrical License to my mail ID:vadrevu_raghava@yahoo.co.in
what r the checklist while installing 500 kva transformer
