starting torque is increased and current is decreased by
using external resistance in a slip ring induction motor.
How??
- 3 Answers
- 6326 Views
- I also Faced
- E-Mail Answers
Answer Posted / nilkanth tailor
THEIR R BASICALLY TWO TYPES OF INDUCTION MOTOR
1) SLIP RING I.M.
2) SQUIRREL CAGE I.M.
GENERALLY, IN HIGH STRATING TORQUES MOTOR(DC SERIES
MOTOR) HAS HIGH STARTING CURRENT, AND ITS VERY DIFFICULT TO
CONTROL THAT CURRENT...BUT IN SLIP RING I.M THIER IS HIGH
TORQUES PRODUCE WITH LOWER STARTING CURRENT THAT IS MAIN
ADVATAGE...
THE MAIN DIFF BET. SLIP AND SQUIRREL CAGE I.M. IS THAT
1)The rotor of the slip ring motor has more windings than a
squirrel-cage rotor so that induction voltage is higher and
the current for the same field strength lower.
2)During start-up the a typical rotor has 3 poles connected
to the slip ring. Each pole is wired in series with a
variable power resistor.
3)During start-up the resistors reduce the field strength
in the stator. As a result the inrush current is reduced.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
what happen if drive input fail momentry at 48.5 HZ frequency?
Power Factor Correction Panel (Manual & Automatic)
Whether the vacuum contactor requires Short circuit protection?If No,why?
On what basis the the size of Lightning arrester for buildings are selected ?
why sielent pole is used only in hydro generators and not in turbo generators
Why do we need interlocking in a HT metering or Ring main unit switchgear?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
Can you explain about TEE protection scheme?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
how to maintain frenquncy with syncronising sub-station for distribution
what kelvin's law ?
