what is the conductor size in 33/11 kv line
- 5 Answers
- 22763 Views
- Al-Thamer, I also Faced
- E-Mail Answers
Answer Posted / vasu
0.2*20cm
| Is This Answer Correct ? | 9 Yes | 14 No |
Post New Answer View All Answers
can i use 2000/5A Clamp meter to measure HT cable
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
Safety of on line ups
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
how 650 volts creates? where is use?
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
what are the protecyion of transformer & generators
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
How to decide whether A / B / C / D curve type MCB should be used?
what is efficient motors and how it is different from normal induction motors
How do we calculate over and under frequency tolerance from generator data?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
