Answer Posted / ronny govender
is a component of liner escalation as the temp increase the
resistance increases
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
You are of electrical field and you are going for software? Why
defination of lines
state the working principle of incondenscent tube?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
What is kirchoff ’s current law (kcl)?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is creepage distance..... what will be the value for different voltage level
how was your last weekend.
how to changeover ups in this power failur time?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
Power Factor Correction Panel (Manual & Automatic)
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
