Why an electromagnetic flow meter cannot be used for gases,
steam and oil flow measurements?
Answer Posted / atul $onawane
electromagnetic flow meter works on the principle of fadays
law of induction. in this voltage induced in the conductor is
proportional to the velocity of fluid(conducting). only
conducting fluids and gases are used .
Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
What are the greenhouse gases in earth's atmosphere?
X is strong but has a very low density (1% of traditional earth materials.) and hence light weight. It is a recyclable material. The compression behaviour of X is strain rate dependent. Higher strain rates result in higher initial modulus and higher compression strength. It can also withstand unlimited number of cycling loading provided the repetitive loads are kept below 80% of the compressive strength. The internal structure of the material includes air-traps which make it poor heat conductor. X is non- biodegradable and chemically inert in both soil and water. Most acids and their water solutions do not attack it; however strong oxidizing acids do. Solvents which attack X include esters, ketones, ethers, aromatic and aliphatic hydrocarbons and their emulsions, among others. It does not support bacterial/fungal growth as well .It also has significant acoustic properties and effectively reduces the transmission of airborne sound. X is combustible and should not be exposed to open flame or other ignition sources. Combustion products are carbon monoxide, carbon dioxide, water and soot. Long-term exposure to sunlight causes yellowing and a slight embrittlement of the surface due to ultraviolet light. X is able to withstand the rigours of temperature cycling, assuring long-term performance.
How instrument air is continually supplied in process plant?
what is AZ431 & how to check it by using multimeter?
How can the particle size distribution be determined in a given bulk solid?
What do you understand by wet bulb globe temperature?
Is there a rule of thumb to estimate the footprint of a cooling tower during design phase?
What is a common source of error in determining the percent spent caustic in refinery applications?
What does capacitor load means? How does it connect?
What factors go into designing the vapor space of kettle type reboiler?
print a pattern of abcdcba abc cba ab ba a a ab ba abc cba abcdcba
What types of valves are recommended for slurry services?
what is the difference between car seal close/open valves and lock close/open valves?
how does refractive index detector work?
hi can anyone tell me some technical questions asked in iocl