Interested to Buy Any Domain ? << Click Here >> for more details...
When batteries are connected in series the voltage increases
but the current remains unchanged, how can this be?
When you consider ohm's law. i.e.
If voltage increases, current increases, providing
resistance remains the same.
- 10 Answers
- 13081 Views
- I also Faced
- E-Mail Answers
Answer Posted / naresh kumar dhal
In series ckt voltage sourse is additive and current
remains the same.It is the property of a series ckt.
Ohms law has no relation to the abovw question.Ohms law
applicable to pure resistive ckt only but physical
condition should be constant.
You have written a wrong thing that resistance remains the
same.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How i can calculate current of cable according to ares?
2. What are the parameters of EHT sub-station?
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
List the disadvantages of constant k filters?
What is dc current source?
how to select the isolation tranformer for siemens 802dsl cnotroller
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.
what is value of Jin transformer
what is the voltage between earth to neutral in lift.
What test must you do before powering up a circuit that you have been working on?
