what is means of CLASS in current transformer name plate?
- 3 Answers
- 6278 Views
- I also Faced
- E-Mail Answers
Answer Posted / kishore
CLASS IN A CURRENT T/F INDICATES THE ACCURACY OF THE C.T.
AS WE NEED HIGH ACCURACY FOR PROTECTION & METERING AS WELL.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is the difference between fault current ant short circuit current?
What are the types of feedback oscillators?
what is high and low cut off voltage of BB and DG at SPS????????
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
What are the three constants associated with a steady state error?
What do you understand by avr?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
what is difference between bus coupler and auto transfer switch
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is dynamo function in DG sets and draw block diagram?
What are the different methodes for calculating the short circuit Current?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What do you mean by distribution transformers?
Inverter. converter. Ups.MCB.solar.alternators. motors.
