How we Use DC Power in Transformers? is it possible ?
- 6 Answers
- 6401 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
basically, transformer consists of primary and secondary
windings of some turns.this winding can b compared vid an
inductor of some turns.so inductor vil allow dc to flow
through.if the input is closed ckt,current vil be flowing
which finally leads to core saturation.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
how harmonics generated in induction furnance? how minimise it?
how many synchronous motor are there in any power plant
aternator every parts and its working
Pl.brief me any electrical major fault you have rectified.
please send me last 5 year interview questions
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
Difference of induction motor & servo motor ??
how to deside the capacity of chock for drive?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
What does the kvar means?
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
