How we Use DC Power in Transformers? is it possible ?
- 6 Answers
- 6395 Views
- I also Faced
- E-Mail Answers
Answer Posted / charan
If i pass DC power in T/f means what will happen ??
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
trasnfarmaer core make
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
what are the assumptions made in swineburne's test?
While testing LA mast,What are the parameter limits ?
What is formula calculation size cable wire ?
bsnl tta exam question
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
How to design the earth grid for lightning protection in an industry
What is the equivalent circuit of a transformer and its vector diagram?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
