How Cable Size is determined for a Particular load.
- 4 Answers
- 6161 Views
- I also Faced
- E-Mail Answers
Answer Posted / hareesh k.s.
depends nature of load.if load is motor cable should
withstand high starting current.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how the aircraft outer body and inner body is separated ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
List the advantages of star-delta starter with induction motor?
how technical is calculated in 11kv line and lt line
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what is Fan Control Cubicle
Testing procedure of DG alternator stability test
What is mason's gain formula?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
How is the percentage impedence of a transformer fixed at design stage???
What is PEC??Applications........
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
How efficiency of thermal plant can be improved?
How isolater function when installed inelectrical 440V wiring
