typical per KM resistance values of ACSR DOG conductor for
33KV & 11KV OH system?
typical per KM resistance values of XLPE 300Sq mm cable for
33KV system?
typical per KM resistance values of XLPE 185Sq mm cable for
11KV system?
- 2 Answers
- 20562 Views
- wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / satish
A.C Resistance per KM of ACSR DOG conductor is 0.397 ohm at
65degrees centigrade.
For 11 KV 3*185 XLPE cable mm resistance=0.211 ohm/Km
reactance =0.101 ohm/Km
capacitance=0.385 micro farad/km
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
Name a govt approved university which have 100% online engineering course.
What are the basic elements used for modeling mechanical rotational system?
how does a liquid starter reduce the starting currents?
difference between crane drive and line drive.
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
how to decide the panel size like MDB ,SMDB PANEL SIZES
When will you multiply and devide with derating factors to the actual value while sizing the cable?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
why the projects getting loss?
What is stepper motor?
Why does inductive loads consume KVARs?
what is the thumb rule for determination resistance of resistor?
What is core CT & it's function?
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
