How Cable Size is determined for a Particular load.
Answer Posted / k.prakashchandra
carrying capacity for cu cable is taken as 2.5 A and 1.5
for Al, per sq mm.In case of generator as the load is
continuous at full value ,they are taken as 1.5 and 1
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
why normally Generator rating are between 11Kv to 22Kv?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
how to avoid Saturation in C.T?
can any tell me why slope 40% and 80% is calculated in differential protection?
What is ST and specify its range of voltage.
what is charger supervision and control supervision?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
How can we calculate ac current from the given DC current when AC voltage is given?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
What are the advantages and disadvantages of the ac motors?
why we are using earth pit in sub stations.?
What are the electrical engineer roles and responsibilities in chemical plant?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.