what is the difference between sensor and tranducers?
- 12 Answers
- 15322 Views
- I also Faced
- E-Mail Answers
Answer Posted / harish
sensor is only used to measure the physical quantity such
as (temp,flow,level,pressure) but transduser is a device
used to measure the physical quantity and convert the
electrical engergy
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the PLC configuration in Cement industry?
How many ohms are required for proper earthing?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
What is the use of gauge?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
How to Calibrate Flammable gas detector in field
How can measure flow in oil line?which type of transmitter is generally used?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
key phaser where is use and work
in mass flow meter what is drive friquancy ?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
