Interested to Buy Any Domain ? << Click Here >> for more details...
11/.433KV, 100KVA TRANSFORMER is supplied with .433KV AT
ITS PRIMARY. HOW MUCH KVA IT CAN SUPPLY
- 8 Answers
- 18772 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / vikas
As the xmer is havin its rating in kva so it depends only on voltage and current so if voltage increases thn current decreases and vice versa so if primary voltage is increased so its current decreases nd vice versa. So if secondary voltage is 11kv thn current in secondary will increase so i think kva will remain same.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
How to test Alternator stability test for REF relay
Vaccum circuit breaker
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
How out of step protection relay works?
Explain what are inter-poles and why they are required in a dc machine.
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
what is the difference between unarmoured & Flexible cable? How to identified?
State thevenintheorem?
WHat is the general checks required for Dry type transformers
Why transformer used in UPS??
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
what will happen if there is a voltage leakage or current leakage in an electrical train
Why power factor should not be in leading (capacitive) mode of any load.
