what is the reason for balance of voltage in magnetic
balance test?
- 2 Answers
- 6969 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The magnetic balance test is carried out on transformer for
detection of shorted turns and core problems.As the results
recorded on individual phases are compared ,test voltages
should be the same for each phase
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
why on delay timer used for fully automatic star delta starter?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
What does the a,b,c of 95a,95b,95c relays denotes?
Define reserve-generating capacity?
derive DC RMS value for half wave rectifier?
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
how the phase convertor changes the no. of phases
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
What is the relation between frequency and motor rpm?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is 3rd Harmonics? how it is generated in alternator
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
Difference between earthing & grounding.?
