Is there devices to convert mechanical energy/rotational
energy into electrical energy.......?
PLease suggest me....
- 6 Answers
- 10206 Views
- I also Faced
- E-Mail Answers
Answer Posted / u.nathan
piezoelectric crystals convert mechanical
energy(eg:pressure)to voltage and it also again convert
voltage to mechanical energy
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
What is the cascade control
What is hp & mp seperator .& what is its working principle ?
how do u calibrate the vacuum transmitter if it shows more reading
how do we commission inergen system?
What is Erosion in a control valve?
what is SIL 1 2 3
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
how the arrangement of equipments done in control room
how do calibrate the valves.. with clear manual
