Explain Why Nozzles are made convergent and Divergent?
- 8 Answers
- 20529 Views
- I also Faced
- E-Mail Answers
Answer Posted / akash patel
in order to increase the velocity of flow of fluid nozzles r made convergent in shape
while where there is necissity to get high pressure of water they r made divergent
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
Define steam turbine diaphragm?
what type of question has been asked at schwing stetter
What for admirality brass used ?
Explain the principle of Suizer Fuel oil injection pump
What are the basis on which the best material for sliding contact bearings manufacturing?
What is the Self & starter? what does it do in the in Genset
What do you treat in high alkalinity of boiler water? What is a feed water pump? What is a Booster pump?
why does bitumen heated from top side bt not from bottom side€
Enumerate the cause of pumps low delivery of water
What phenomenon becomes when air mixed with refrigerant?
Which country has the worlds most powerful tank?
what's the diffrent between k engine series and qsk engine series and specialey fuel system
What was the spinning jenny?
What is the boiler bank position?
What type of boiler does not need a steam drum ?
