Interested to Buy Any Domain ? << Click Here >> for more details...
how much current will take for 1kw power. and what is the
eqoutiion which is connecting with kw and A.
- 2 Answers
- 12979 Views
- I also Faced
- E-Mail Answers
Answer Posted / saju
Full load current =kw*1.78 so, 1.78A will take for 1kw
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
Which is the largest hydropower station in the world?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
where lt & ht capacitor used
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
The loads are connected with phase and ground then why current flow as the loads ?
we need a ntpc previous papers
List out the different frequency domain specifications?
which network topology offers the greatest level of tolerance?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
