why we used for range in pnumatic 3-15 psi and current 4-20
ma?
- 11 Answers
- 38253 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / lomesh vadhankar
For 4-20mA, the linearity scale comes proper, as well as if
we want to convert, 4-20 mA than its easy to factorize, in
range of, 0-25%,25-50%,50-75% and 75-100%.. So, If suppose,
any control valve is needed to control, then it will be
easier to control it... And for other reasons, as
Mr.S.I.Saravanamurthy Perfectly said, is the ZERo zone. so
that, the Dead condition of any instrument can be
differentiated from normal Zero parameter condition.
Thank you..
Your comments are welcome
Lomesh Vadhankar
| Is This Answer Correct ? | 10 Yes | 9 No |
Post New Answer View All Answers
what is the reason while warning lamp is on while the engine is cranking?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
How does your previous experience relate to the job you are applying for ?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
Draw bode plot of any transfer function. Why is plotting bode necessary?
what does it mean an active front end in vfd plz explain it briefly
Explain the difference between mmwc and mmwg?
where cascade loop use ?
Name different types of bourdon tubes.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
