Why current transformers are rated in BURDEN instead of VA?
- 4 Answers
- 9387 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / kundan malani
bcz they are low rating so the BURDEN instead of VA... and VA depends in voltage and current
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
can anyone provide me a amf panel control wiring using ec-2 relay?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is the disadvantage in proportional controller?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
what is the stear deltaprinceple?
What will be the current if the resistance total in a series circuit doubles?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
What is knee point voltage?
Why Neutral Isolation is required?
