Interested to Buy Any Domain ? << Click Here >> for more details...
why we use to always generate power below 16kv.why not at
higher voltage?
- 3 Answers
- 6487 Views
- I also Faced
- E-Mail Answers
Answer Posted / tathagata
We can generate more than 16KV but in that case we have to
pay more cost for
“insulation of winding” and the size of generator will be
bigger which will not cost effective.
That why we generated up to 16KV and step it up with the
help step-up transformer up to the required voltage level
and sent it over HV line.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is protection class current transformer.
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
How is the gain affected by the introduction of feedback in a control system.
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
Why is the air gap between the pole pieces and the armature kept very small?
where solid grounding and where grounding through ngr done and why?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
what is dry and wet frequency withstand voltage? why & where it is used??
Define peak time.
What is the difference between circuit breaker and isolator
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
What are the weight of 800KV DA,DB and DC type tower ?
