Interested to Buy Any Domain ? << Click Here >> for more details...
In most process, speed of motor controlled by control
system with a reference pot . Now if i start & it becomes
uncontrollable, i.e.gets directly start & stop after certain
time.Then which reasons can make such problem? can motor
may be faulty?how?
- 3 Answers
- 6241 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / amit
Actually There May be two Reasons Behind the problem
1)The baring of the motor can't bare that much of Voltage
at certain long time.
2)Change in Voltage Can Burn the Winding.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
What is standard procedure of manual mapping in Radar type level transmitter?
Gas equation
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
what is the process to make control schematic ?
How can a d.p. Transmitter be calibrated?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
how to calibrate 0- 150 psi presure gauge by dead weght tester
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
how can leve transmetter calibate in feild .and also put cv and flow plz .....
how can use ram
How earthing can be checked????
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is gas metering system? gas chromatograph? and gas compressors?
Isometric drawings are generated during _________________ phase of a project
