AC voltage only create magnetic flux in coils, but in Solenoid
coil how 24V DC volt create flux and pick the plunger
- 5 Answers
- 10701 Views
- I also Faced
- E-Mail Answers
Answer Posted / virendra
Minakshi i am bit agree with you but i think that when a
current passing through the wound coil a magnatic field is
develod which pull the iron plunger hence the contactor
pics. in any from of current AC or DC magnatic field will
be develop the only diffrence is that in AC wave form is
sinosodule & while in DC it is linear...Please correct me
if i am wrong
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
what is the voltage between earth to neutral in lift.
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
what is the meaning of the symbol << >> put in transformer drawing
Define phase lag and phase lead?
What is reverse power relay?
what is effect of 5amp fuse on 2mva pry protection of transformer
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
What do you mean by per capita requirement of electrical energy in india
What are the special cables required for explosion proof wiring?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
give me atleast four differences between circuit and network
What must be the minimum distance maintained between 2 Generators as per International standards?
