Answer Posted / vikas katoch

1.to reduce friction
2.to reduce the leakage

i am preparing for motor vehicle assistant inespector please send me old questions papers.

1951

---

3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament

1919

---

why we use kg/cm2 in pressure gauge not kg/m2

3194

---

3-4 questions on optical fiber : data based.

2713

---

how to calculate duct fittings surface area ?

4479

---

what shows avribiations related to bearing blocks

2085

---

How to disiegn DCV circuit ?

2802

---

Classification of bunkers?

2229

---

In terms of electrical enhineering, give a detailed explanation of the "earth fault loop path"

2372

---

Where do you put the oil in a compressor?

1211

---

HELLO SIR VERY GOOD EVENING SIR, I'M KALAMANI. I NEED TO PREPARE FOR UPCOMING "JINDAL STEEL AND POWER LTD" INTERVIEW. I'M MECHANICAL ENGINEER SIR. SO PLEASE SEND ABOUT JINDAL's PREVIOUS APTITDE TEST QESTION PAPERS TO MY MAIL ID : , , . I WANT TO KNOW ABOUT THEIR PROCEDURE TO BE HELD ON THE INTERVIEW? SO PLEASE SIR SEND UR VALUABLE ANSWER TO ME ON ABOVE MAIL ID SIR. THANK U SIR.

2041

---

what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

2102

---

What are the different types of bearings?

1164

---

What is blast furnace

5599

---

How convective heat transfer is effected and on what factors it depends ?

1170

---