Define magnetic flow meter and mass flow meter.
Answer Posted / kumar
Mass Flow Rate represents the amount of mass that passes a
specific point over a period of time.
Mass flow rates are used to measure the weight or
mass of a substance flowing through a process
operation. If the volumetric flow rate and density
are known, the calculation is based on the formula
W = Q x r
where
W = mass flow rate
Q = volumetric flow rate
r = density (r = density “rho” )
Megnetic flow meter:
What is a Magnetic Flow Meter?
A magnetic flow meter (mag flowmeter) is a volumetric flow
meter which does not have any moving parts and is ideal for
wastewater applications or any dirty liquid which is
conductive or water based. Magnetic flowmeters will
generally not work with hydrocarbons, distilled water and
many non-aqueous solutions). Magnetic flowmeters are also
ideal for applications where low pressure drop and low
maintenance are required.
Principle of Operation
The operation of a magnetic flowmeter or mag meter is based
upon Faraday's Law, which states that the voltage induced
across any conductor as it moves at right angles through a
magnetic field is proportional to the velocity of that
conductor.
Faraday's Formula:
E is proportional to V x B x D where:
E = The voltage generated in a conductor
V = The velocity of the conductor
B = The magnetic field strength
D = The length of the conduc
Is This Answer Correct ? | 27 Yes | 1 No |
Post New Answer View All Answers
Full form of KKS when use DCS.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
detail of mass flow meter pricipal
What is cut off relay? And why use in PLC and DCS?
what is droop in governer ,type of droop ,how it work
selection of the zener barrier for the hazardeous area zone 0
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How to Calibrate Flow Switch in field
field bus transmitter calibration procedure tell me
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
Calibration of controller (pneumatic)
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
How to measure the dust in chimney(spm)?