Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh kakatkar
for the control of any circui few amperes of current is
required so normally we use a small cross-sectional wires.
This current can be mA to Few Ampers and risk of FAULT
current flowing is less and normally a single phase so we
require a small cable of 2 core or 3 core or less cross-
section.
The power cables is used depending on the application in
the Amperes to KA and the FAULT current is more and in the
range of KA.So the application of this cable is to supply a
several Ampere of current and Voltage ranging from the 230
V to Several KV depending on the load.So this cable is
called power cable as it is used to feed power.
Even based upon the application the cables are called as
Power and Control Cables.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What are gain margin and phase margin?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
What is the difference between grid and off- grid system??
What are the advantage of free wheeling diode in a full wave rectifier?
Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
What is instrumental error?
how to calculation increase power factor for single phase
why we used ZNO in Lightning arrester.
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
what is the difference between an alternator and a synchronous motor
