Why the industry's standard current standards are from 4mA to
20mA,not from 0mA or any other range?
- 3 Answers
- 6586 Views
- I also Faced
- E-Mail Answers
Answer Posted / pramod
Answer 1 is also a reason
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
use of split range ? where it is used ? in which control loop it is used ?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is 24vdc live and dry supply
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
what is the usage of QDV & VOLUME BOOSTER
In turbine what does term CDP, NH, HSSOC means.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
What is 3 selection available when configure the burnout protection for controller
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
