Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any option to replace two Genset of capacity 125KVA
with one higher capacity for same office?
- 8 Answers
- 9382 Views
- I also Faced
- E-Mail Answers
Answer Posted / loboreliance2003
Like Mr.KPD has said that not enough details are given. If
the office already has the setup of 2 gensets of 125kva
with all installed switchgear, panels, changeover switches,
cabling etc. then it is very very difficult and costly to
replace with one single DG set of higher capacity.
If these smaller gensets can be shifted to another location
then okay it can be done. If space is a constrain then well
we can go ahead and do the change. But remember earlier you
had option of running only 1 DG set and saving fuel and
wear and tear.
Once you upgrade to higher capacity then you will have to
run the same even if actual power consumption is much
lower than capacity of DG set.
There are many permutations and combinations involved and I
can help if you can give me all details of the requirement.
williamloboatrediffmaildotcom.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why the efficiency of generator is more than motor in swinburne's test
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
What is the difference between Droop vs Isoch Control?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
how we can calculate chiller required ampear?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
how we explain parallel paths armature winding?
Why efficiency in thermal power plant is low?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
What are the properties of a resistor?
which type of questions asking for solar companies?
How much ph is maintained of water resistance starter for slipring induction motor ?
What do you mean by pull of electromagnet?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
use of choke in APFC panels
