What power factor maintain you maintain at u r organisation
Answer Posted / manish singla
I have always maintained Power Factor 1 (Not Leading Nor
Lagging) during my days with Maintenance Deptt.
Resulting in saving of Atleast Rs40k in monthly bills,
Better Voltage etc.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
What is dynamo?How it works and what is the function of dynamo in a DG.
clarify types of motor operated valves and advantages
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What are the different circuits in thermal power plant?
what is the sludge current
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what are the interview question asked in wind mill about electrical
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
please send me privious exam's queation papers of section engineer(electrical).
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes