Answer Posted / cnu
1M Ohm is the resistance value. other than this the
resistor is rated with wattage like 1/2 watt, 1 watt so on.
so the i*i*r value of that corresponding resistance shud
not be more than the wattage rating of the resistor. this
determines the current value. when u know the current value
eventually you get to know the voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why the output of OP-AMP is always less than Vcc?
what are the pecularity of shaver sockets ?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
i want to know that what is the eligibility critaria for ongc exam?
What is non-minimum phase transfer function?
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
How to know vacuum in vacuum cylinder of breaker in working condition
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
how many joints are allowed in underground HT cable of 1 KM
On what basis the the size of Lightning arrester for buildings are selected ?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
