Answer Posted / nam@yahoo.com
Who Is The Blody U.Chandraseker
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
How to calculate MCB Breaking capacity.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
What type of fittings and electrical accessories can be install in radiation area ?
how can motor both beasrings insulation resistance can be check?
diff b/w normal grounding and resistance grounding
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?