what is the operation of UPS ?
can any one answer me?
- 7 Answers
- 7243 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
ups will be present between the equipment and power socket.
the electricity flows from socket to ups n then to
computer, battery continuosly checks the power levels and
also collects the power.when the power levels are not
within the normal parameters, ups vil connect the batteries
for compensating the lack of power.whwn the power is
restored to the normal flow,ups vil start recharging the
batteries.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
what is lumped and distributed elements?
for what purpose the star point is done in ct
A low wet bulb temperature indicates
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Is vtg is controlled by the resistor? if else how much?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
what is charger supervision and control supervision?
any application of back emf
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
