Interested to Buy Any Domain ? << Click Here >> for more details...
what is the principale of vortex flow meter.
- 7 Answers
- 13621 Views
- Ambuja, India Glycols, I also Faced
- E-Mail Answers
Answer Posted / mrfa
It has crystal's inside when process pushes they create
milivolts .
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
How RAL(Rotary air lock)works in cement industry?
What is intrinsically safe system?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
Identification of ss fittings, pilot valves, relief valve.
what is cold loop? difference between hot and cold loop?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
In turbine what does term CDP, NH, HSSOC means.
how can use ram
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
How do you identify an orifice in the pipeline?
